Rebir IE-5708M
Videos 5Photos 3 | Expecting restock 10 890 ₴ Power consumption (W): 2250; Rotation speed (rpm): 15000; Planing width (mm): 155; Planing depth (mm): 3.5; Grooving depth (mm): 17; V-grooves: 3; Knives: double sided; Dust removal: bilateral; soft start; edge guide; stationary installation; Power source: mains (230 V); In box: |
Rebir IE-5708M | |||||||||||||||||||||||||||
|
Information in model description is for reference purposes.
Before buying always check characteristics and configuration of product with online store manager
Catalog Rebir 2024 - new products, best sales and most actual models Rebir.
Before buying always check characteristics and configuration of product with online store manager
Catalog Rebir 2024 - new products, best sales and most actual models Rebir.
Powerful, with such a planing width, less power is indispensable. And this one stalls with a removal thickness of up to 2 mm on a beam from under the sawmill.
Planed 20 cubes of timber 150 on both sides and chamfered. It cuts cleanly enough until the knives get hooked, now the knives are turned over. Heavy - rather dignity, no need to press down, just lead. The shavings get clogged, so it's raw! The button is tight, but this is necessary so as not to relax and fully control the heavy, powerful and rather dangerous device. I didn’t put it in the hospital and I won’t try - it’s clear that the equipment for this is completely “weak”. There is no adjustment of the thickness of the cut, I put it on the "peephole" use Rebir IE-5708M month or more |
1 out of 3 user review(s) shown
2 more user review(s)
Video reviews
We recommendCompare using chart →
2. Install a stand for fixed installation in the front and use as a handle for the left hand - very convenient, it is better to wrap something else, less vibration. In this case, you will not hold on to the cutting depth setting knob and loosen it. And it is convenient to put it vertically on the front end.
3. When processing a width of 150mm or a little less, install a guide ruler - a good stop, it will not flicker.
4. On a damp tree, do not take more than 2 mm, it will get up, and the anchor can be burned, repair - replacement of the anchor 2-3 thousand.
5. Run only at idle and wait 2-3 seconds until such a colossus spins up.
6. Take a wooden block 20x20x300mm, sharpen it under a sharp wedge on one side - it’s convenient to push the chips out of the planer cavity, I do it on the go with my left hand. If it gets under the knife, nothing dangerous - it will cut a little. Only not solid wood and not iron !!! This solves the problem with chip clogging.